Titration Test for Homemade Biodiesel

Testing Waste Vegetable Oil with Titration

Chemistry equipment
WLADIMIR BULGAR/Getty Images

One hundred percent virgin or lightly used waste vegetable oil (WVO) requires 3.5 grams of lye per liter of oil to cause a biodiesel reaction. Heavily used oil can require significantly more, and must be tested to evaluate its acidity. Titration is a common method used to determine the appropriate amount of lye (base) needed for a particular batch of WVO.

Titration

Equipment:

  • an electronic scale or beam balance
  • 2 beakers or jars
  • a graduated dropper
  • litmus test strips or electronic pH meter
  • lye
  • isopropyl alcohol
  • distilled water

Following are the steps to complete a titration test:

  1. Measure 1 gram of lye on a scale.
  2. Measure 1 liter of distilled water into a beaker.
  3. Thoroughly mix the gram of lye with the liter of water until it’s dissolved.
  4. Measure 10 milliliters of isopropyl alcohol into a separate beaker.
  5. Thoroughly mix 1 milliliter of used vegetable oil into the alcohol.
  6. With a graduated eyedropper, put a 1 milliliter drop of the lye/water mix into the oil/alcohol mix.
  7. Immediately check the pH level of the oil/alcohol mix with a piece of litmus paper or an electronic pH meter.
  8. Repeat step 7, keeping track of the number of drops used, until the oil/alcohol mix has reached a pH level of between 8 and 9--normally no more than 4 drops.
  9. Calculate the amount of lye needed for the biodiesel reaction by adding 3.5 (amount of lye used for virgin oil) to the number of drops from step 7. For example: suppose a titration uses 3 drops of lye/water. Adding 3.0 plus 3.5 = 6.5. This hypothetical batch of oil requires 6.5 grams of lye per liter of oil.